- 分享
- 0
- 人气
- 11
- 主题
- 113
- 帖子
- 3279
- UID
- 429035
- 积分
- 2766
- 阅读权限
- 20
- 注册时间
- 2011-7-4
- 最后登录
- 2017-4-28
- 在线时间
- 6486 小时
|
本帖最后由 yipsoutseng 于 2013-6-19 05:24 PM 编辑
walao007 发表于 2013-6-19 05:08 PM
不会看
下载Odin3.07.zip
下载CF-Root for SGS3 v6.4
然后根据以下教程(懒得翻译中文):
How to install using: (desktop) ODIN
Short: unpack the ZIP download, you will end up with a TAR, flash this in ODIN as PDA, and optionally install and run Triangle Away afterwards to reset the flash counter. Beware that this should boot your device into recovery mode (for a few seconds to install SuperSU and CWM Manager) after flashing. Sometimes it doesn't, just flash it again in that case.
- Follow these instructions to the letter. Do not touch any buttons or checkboxes that are not listed below to touch!
- Unzip the attached Odin3-vX.X.zip file
- Download and unzip the CF-Root-SGS3-vX.X.zip file
- If you end up with a recovery.img and cache.img file, you've extracted twice. You need to end up with a .tar file - don't extract that one
- (USB) Disconnect your phone from your computer
- Start Odin3-vX.X.exe
- Click the PDA button, and select CF-Root-SGS3-vX.X.tar
- Put your phone in download mode (turn off phone, then hold volume-down + home + power to boot - if it asks you to press a button to continue, press the listed button, or run adb reboot download command)
- (USB) Connect the phone to your computer
- Make sure Repartition is NOT checked
- Click the Start button
- Wait for Android to boot
- Done (if it took you more than 30 seconds, you need practise!) |
|